Hi!
In part 1 about the new Stereo Power amp in tower chassis, I showed the initial construction steps. Here photos of the finished amplifier.
It contains the entire amplifier including power supply in a single chassis 305*305mm, 400 mm high (plus height of tubes and feet.
The amp is configured for 8 Ohm speakers. Driver tubes are 6SN7 with both halves in parallel to get lower impedance. The drivers are transformer coupled to the output. Rectification is done with a bridge of 6AX4 damper diodes.
It already arrived in its new home where it will be used as part of a multi amplifier system together with 801A drive 300B monos.
So a matching color scheme was used to fit with the amps which were already in place.
Best regards
Thomas
No comments:
Post a Comment